- This controller quadrant offers TPM, flaps and trim wheel controls for flight simulators. The controller features push pull controls for each throttle, prop and mixture. A momentary switch for flaps, push up to raise flaps one notch and push down to lower flaps one notch, the switch auto returns to center. Also features a trim wheel for fine tuning the elevator during flight.
This controller has M5 nuts in the lid and base for mounting either above or below on your desk/cockpit. When mounting below please allow approximately a 2.75" overhang off the front to allow clearance for the trim wheel section.
- No drivers are needed, just plug and play in Windows and Mac. Been tested and works perfectly in Microsoft Flight Simulator 2020 and X-Plane. It should work with any game that uses a joystick/controller in Windows as well.
- This controller is 3D printed and hand made by me. Uses quality brand named linear sliders/potentiometers and uses a Leo Bodnar USB controller board. Includes 6' USB Cable.
- Dimensions: (Main Body) 12" Long, 5.75" Deep, 2" Tall (Trim section 4" Tall).
|Free Domestic Shipping and Includes a 1 Year Warranty.|
I admire the construction of the TPM, The metal throttle axis rods work very smoothly, and remind me of the real deal.
The 3D Printed quality is great (clean surfaces). I'm also excited to make use of the trim wheel in my flights!
Shawn was incredibly helpful, and resolved issues with upmost professionalism.
Haven’t been able to fly with it yet but it was easy to set up and sync with X-Plane. I like the clean simple non-gimmicky look.
I couldn't be more pleased. FS2020 immediately recognized the module. Set up and calibration took less than three minutes. The controls function flawlessly and give the sim an addition degree of realism. Most impressive, however, was Shawn's willingness to modify the module to better integrate with my setup. I can't imagine any other flight sim accessory manufacturer doing the same.
High quality and realistic product. Only improvement to suggest would be adjustable gearing on the trim wheel for MS sim 2020
The FlightSimStuff TPM with Trim Wheel and Flap Lever Control Hardware is a Great addition to my desktop Sim! Works Perfectly with my X-Plane 11 Single Engine Cessna’s and Mooney Ovation. I highly recommend this product to the Flight Simmers out there! Keep up the good work FlightSimStuff! I look forward to more products, in the future!